====== Advanced firmware upload options ====== ===== mtd ===== * Login to Lima and download binary image to RAM. (Alter IP and path to match your binary image location) scp test@192.168.0.104:/home/test/openwrt-8devices-v2.9-ar71xx-generic-lima-squashfs-sysupgrade.bin /tmp * Perform upgrade procedure. mtd -r write /tmp/openwrt-8devices-v2.9-ar71xx-generic-lima-squashfs-sysupgrade.bin firmware ===== Manual U-boot TFTP flashing ===== **These instructions are for Lima board** * You will need TFTP server running on your PC. On Linux install package 'tftpd-hpa', on Windows - [[http://tftpd32.jounin.net/|TFTPD32]]. * Put sysupgrade image to your TFTP folder. * Reboot or power up Lima with serial console running and connected to PC. U-Boot 1.1.4-g4ef14f8b-dirty (Apr 11 2016 - 14:56:54) ===================================== Caraboot v2.5-dev (QCA9531) U-boot http://www.8devices.com/ ------------------------------------- DRAM: 128 MB Flash: 64 MB Net: eth0, eth1 ===================================== Hit '' key(s) to stop autoboot: 0 ath> * Press to enter U-Boot console, press few times to clear console buffer Hit '' key(s) to stop autoboot: 0 ath> INTERRUPT> ath> * Set IP adresses of TFTP server and device (adjust addresses to match your setup): setenv ipaddr 192.168.1.1; setenv serverip 192.168.1.20 * Download firmware from TFTP server (file name can be changed if you need) ath> tftpboot 0x80060000 openwrt-8devices-v2.9-ar71xx-generic-lima-squashfs-sysupgrade.bin eth0 link down enet1 port1 up dup 1 speed 1000 Using eth1 device TFTP from server 192.168.1.20; our IP address is 192.168.1.1 Filename 'openwrt-8devices-v2.9-ar71xx-generic-lima-squashfs-sysupgrade.bin'. Load address: 0x80060000 Loading: ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ################################################################# ###################################################### done Bytes transferred = 3932164 (3c0004 hex) ath> * Next step erases old firmware and writes the new one. **Only** perform it, if previous step was successful and '''Bytes transferred =''' matches actual size of firmware image file. ath> sf erase 0xC0000 +${filesize}; sf write 0x80060000 0xC0000 ${filesize} SF: 4194304 bytes @ 0xc0000 Erased: OK SF: 3932164 bytes @ 0xc0000 Written: OK ath> * Flashing is done, you can reset the board reset